How To Clean Msi Gt72 Dominator Pro

MSI GT72 2QE Dominator Pro Battery Replacement

• Comments: 20
• Favorites: three
• Completions: 25

• Battery 10 steps

Introduction

This guide will tell MSI GT72 2QE Dominator Pro users how to replace a defective battery. It is a medium-level process that takes 15-xx minutes to consummate.

For your safety, discharge your battery beneath 25% earlier disassembling your device. This reduces the run a risk of a dangerous thermal event if the battery is accidentally damaged during the repair. If your battery is bloated, take appropriate precautions.

• Double Sided Agglutinative Record
• Precut Adhesive Card

• Be sure to power off and unplug your device earlier you lot begin your repair.

• Utilize a Phillips screwdriver to remove the vii 6mm screws from the bottom of the laptop.

• Lift and remove the lesser case off of the laptop.







• Utilize a Phillips screwdriver to remove one 4 mm screw and one 10 mm screw from each fan.

• The 10mm fan spiral won't really come up out, equally it is fastened with rubber piece to fan. Unscrewing it from the lower instance will allow for removal, though.

• Unplug both fans by gently disconnecting the fan connector from its motherboard socket. If you accept trouble, gently wiggle the connector to loosen it.

• Unplug the SATA cable and remove the hard drive.

• Brand certain to pull cable straight out in order to ensure it stays intact.

• Remove two 6mm Phillips #0 screws and remove the M.ii SSDs.

• Make sure you lot pull SSD straight out so information technology doesn't get damaged.

• Unplug both red and blackness speaker cables. Pull direct out so the connectors aren't damaged.

• Disconnect both these cables carefully by lifting the pressure tabs then gently pulling.

• Unplug the battery cable.

• Pull straight up and then every bit non to damage pins.

• Remove xv 5mm Phillips #0 screws and remove inner case.

• Case may take some force to remove, but don't utilise excessive force or you lot risk breaking the plastic connector tabs.

• Employ a card or other apartment object to elevator and remove the battery from the housing.

• Exist extremely careful removing the battery. If punctured, chancy chemicals tin exist released, or the bombardment could catch fire or even explode.

• Supervene upon the battery with a eleven.1V, 7500mAh Li-ion battery, MSI part number: BTY-L77 or equivalent.

• Run MSI Battery Calibration to brand sure the firmware can see the new batteries cycle high depression voltages.

Almost done!

To reassemble your device, follow these instructions in reverse order.

Conclusion

To reassemble your device, follow these instructions in reverse gild.

Kevin Shipp

Member since: 04/xviii/2017

846 Reputation

one Guide authored

Squad

15 Comments

Source: https://www.ifixit.com/Guide/MSI+GT72+2QE+Dominator+Pro+Battery+Replacement/88717

Posted by: mcgheeallegs.blogspot.com

Share this post